-
Our picks
-
UltiMaker Cura 5.4 stable released
ArunC posted a topic in UltiMaker Cura,
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!-
-
- 58 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
neotko 1,417
Is 'Das Board' XD translated means 'The Board'
JK. For suggestions about the forum is better to post them on
https://ultimaker.com/en/community/11734-general-forum-feedback
Cheers!
Link to post
Share on other sites
SandervG 1,519
haha huh?? When did that happen? ok. I am pretty sure we had it right at some point
Well thanks for pointing it out, we'll fix it asap.
Link to post
Share on other sites