UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
in 15.04.5 (think it's the same in 15.04.4) there is "Infill prints after perimeters" in the Expert-Settings.
On the other hand 70°C for the printbed ... for me it seems a bit high (assuming you're printing PLA <-- Hotend at 210°C?), you could try to lower the bed temperature.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
berndjm 16
Hi,
in 15.04.5 (think it's the same in 15.04.4) there is "Infill prints after perimeters" in the Expert-Settings.
On the other hand 70°C for the printbed ... for me it seems a bit high (assuming you're printing PLA <-- Hotend at 210°C?), you could try to lower the bed temperature.
Regards Bernd
Link to post
Share on other sites