Question regarding CURA 2.3 and UM2

[DLMeyer 0]

Hi all.

Quick question regarding CURA 2.3, would it be possible to set the top/bottom speed independently intstead of lumping them together? Also, would it be possible to provide supports only where needed, or possibly add support manually in CURA? That would be extremely helpful.

Lastly, why is it not possible to use all the "material" settings on the UM 2? I have selected them all in settings, but only "enable retraction" and "z hop" settings become available for use on the print setup panel.

[meduza 191]

Manual supports is not included in Cura yet, i know there are some plans for it, but that will be in some future release.

[nallath 1,123]

Manual supports is not included in Cura yet, i know there are some plans for it, but that will be in some future release.

 

Uh. No. 2.4 will have some support for it.

As for the material support; The um2 handles it's own material settings. As such, you can't set them in the slicer.

Edited December 19, 2016 by Guest