Problem slicing object larger than 180mmx180mm

[mlashcorp 0]

Hello,

I am trying to 3d print an object that is 183x184 mm . Even when trying to print without a priming tower cura 2.4 says that the object is too large. The build volume advertised is larger than 184mm.

Can anyone help in this regard?

Thank you.

[peggyb 171]

here is some more info on the subject:

https://ultimaker.com/en/community/23300-cura-23-not-using-full-print-area?page=1#unread

[herbw 0]

I am following up here, because I am having the problem in Cura 2.4, and the above thread is specific to Cura 2.3.

I get two messages: Auto scaled object to 16% of original size and Nothing to slice because none of the models fit the build volume. Please scale or rotate models to fit.

If Cura is going to scale my model to fit, when Cura is done, the result should fit. When I manually scaled the object to 14%, Cura successfully sliced the model.