UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Bad quality Small Pieces with Ultimaker Nylon
In this smaller model, the printing speeds are generally lower than in a bigger model. I suggest going down in temperature (5-10C) in your next try, that could make a big difference in a model like this.
I also see that you scaled down the print speed, which makes it print the outer walls really slowly. I'm scared that the outer walls get printed at ~10mm/s (this scales with the print speed), which will lead to even more degradation of material. If you really want to print it at those speeds, I suggest going down another 10C in temperature.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Tomhe 21
In this smaller model, the printing speeds are generally lower than in a bigger model. I suggest going down in temperature (5-10C) in your next try, that could make a big difference in a model like this.
I also see that you scaled down the print speed, which makes it print the outer walls really slowly. I'm scared that the outer walls get printed at ~10mm/s (this scales with the print speed), which will lead to even more degradation of material. If you really want to print it at those speeds, I suggest going down another 10C in temperature.
Link to post
Share on other sites