cura 2.4 print 1 at a time retraction issue

[lance-greene 7]

so ive been printing a bunch of spinners lately and am printing 4 on a buildplate, using the "print 1 at a time" setting. I've noticed that when it finishes 1 and then retracts and moves to the position of the next spinner, there is no extrusion for almost the entire skirt and it just barely manages to start extruding when the skirt is finished and the print starts.

i think it might not be priming as far as it is retracting when it is set to "print 1 at a time"

[ianeagland 0]

Hi

I can confirm this. I am sure its a bug. I have increased skirt line count to get round it.

Ian

[bagel-orb 61]

Which version of Cura are you running?

When did you last update the firmware on the printer?

[ianeagland 0]

Hi

Just seen this. Raised an issue on Git and the problem is now fixed.