Thermical drift

[BLOMIX-3D 0]

Dear All,

I'm printing a product, which runs approximately 37 hours. Could it be that the UM suffers from thermical drift?

I seems that it is shifting it print position in Y-axis. A few millimeters. Look at the tower.

I have paused my print now, but is there any way to adjust it, without discarding the current print?

Thanks!

[ultiarjan 1,223]

When your print is shifting most likely you have a loose pulley... have a look here;

http://support.3dverkstan.se/article/23-a-visual-ultimaker-troubleshooting-guide#shifted

I don't see any way to recover that print....