UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
neotko 1,417
24v, no more than 250mA
Edited by GuestLink to post
Share on other sites
amedee 349
Yes -- If you plan to replace the original LEDs, not in addition (just to be clear on that).
If you want to add some (always on) LEDs, you can source the 24v from various places on the board...
Link to post
Share on other sites
chenci 3
Yes i am planning to replace the original LEDs.
This is the seller we have here. They sell LED SMD 5050 24V @60 LED/meter.
Below they say that a power supply of 1250mA can power up to 2.5meters. Using this reference i can calculate the needed LEDs
Hope it works.
Link to post
Share on other sites