Jump to content

Where to get wrench for small Ultimaker 2+ nuts?


pluggedIN

Recommended Posts

Posted · Where to get wrench for small Ultimaker 2+ nuts?

My two side fans are not going on at all. When I issue M106 S200 command, the middle one goes on but not the two side ones. I want to remove the bottom cover, as specified in this issue... but I can't unscrew the two nuts. Very tiny.

Any suggestions as to where I could get a tool loosen the nuts? It is made worse by the fact that I have very little room at the bottom

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...