Jump to content

Temperature readout difference between UMO and UMO+


veedee

Recommended Posts

Posted · Temperature readout difference between UMO and UMO+

Hi guys,

I noticed something lately. I have 3 old UMOs with the thermocouple board on the printhead, the other 4 UMO+s have the sensor (PT100?) attached directly to the main board.

When I print the same gcode file on both types of printers, I get different results. The UMO prints Colorfabb PLA/PHA at 220ºC without stringing and with a smooth but matte top layer. The UMO+ prints with same settings, but there is significantly more stringing and blobs. Also the top layer is a lot more shiny. When I lower the temperature manually to around 200-205, the prints look a lot more like the older UMOs.

I want to do a comparison between the readout of the sensors, but I have to find/make some kind of heater block where both sensor fit in together.

Does someone have an explanation for the difference in print quality? Is the temperature readout wrong on one of the machines?

  • Link to post
    Share on other sites

    Posted · Temperature readout difference between UMO and UMO+

    I always had to print a bit hotter on the UMO compared to the UMO+

    I have no tool to calibrate accurately, so I don't know which one is wrong, but I did the same observation...

    As I had recently troubles with the UMO thermocouple amplifier I replaced the sensor by a PT100 and the E3D amplifier. I have now more consistant temperature reading between both printers.

    • Like 1
    Link to post
    Share on other sites

    Posted · Temperature readout difference between UMO and UMO+

    @amedee, short question: how have you hooked up the E3D amplifier?

    It is relatively straightforward, just connect to the 'temp' connector, as you can see on this picture:

    C93j9xOXUAEehnY.jpg

    .

    Be careful, this picture is from my old 1.5.3 board, on recent boards the order of the pins is different (but it is written on the board)

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...