Jump to content

Cura 2.7 crash


Connor_K

Recommended Posts

Posted · Cura 2.7 crash

I am running a Ultimaker 3 Extended and using cura 2.6 and wanted to upgrade to cura 2.7. I installed off of Ultimaker website and once I clicked to launch, it comes up loads everything until it says "setting up sence..." then completely crashes and closes. Has anyone had this problem??

  • Link to post
    Share on other sites

    Posted · Cura 2.7 crash

    I recommend deleting all the old profile information from cura 2.6 by closing cura, then deleting the %appdata%/cura and %localappdata%/cura folders and then restarting cura 2.7 to see if that helps.

    • Like 1
    Link to post
    Share on other sites

    Posted · Cura 2.7 crash

    I recommend deleting all the old profile information from cura 2.6 by closing cura,

     

    But before you nuke everything, zip it up and post the zip somewhere so a dev can have a look to see *why* it crashed.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...