Jump to content

UM2+ axle out of round

dalind

By dalind
in UltiMaker 3D printers

 Share

Recommended Posts

dalind

dalind 0

Posted
Posted · UM2+ axle out of round

Hi everyone,

I was wondering if someone had to handle an out-of-round axle on an Ultimaker 2+ (upgraded from UM2). My right y-axle seems to have this issue, you can see two videos of the problem here:

https://streamable.com/gq0u9

https://streamable.com/nm6qn

Prints are still running fine, but I am concerned this might become a real issue in the (very near) future.

Do you think I need to replace the whole axle and if so, where could I buy it?

Thanks!

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...