Cura 2.7 Skin

[radek45 0]

Hello,

I cannot find this in any please.

Could You tell me what is skin in Cura 2.7?

is it outer wall??

Sorry for ignorance but im new to Cura, and I am not sure about this.

Radek

[gr5 2,230]

"shell" is the total thickness of the outer walls (not including the infill pattern). outer wall is the thickness of the outer most pass. Usually it should be exactly the same or a little less than the nozzle width. There are inner shells as well.

I don't know what skin is. There is a something about "top skin". I don't know what that is exactly. I have that always set to 0.

[radek45 0]

Thank You gr5, for Your answer.

I am familiar with outer and inner walls, but think is about skin, Cura 2.7 is the first time I see this parametr (normally i use repetier), but becouse of lack of the parameters (in Slicer nad Cura engine), I decided to move into Cura for slicing models.

My idea for skin is that Cura call outer wall - skin? But I am now sure about that.

Radek