Stu
thanks for asking I'm putting the printed parts to gether today but just found that the magnets are not a tight fit they push into the recess but don't stop there. I'm pondering the use of super glue ?? any thoughts, the printer is not apart at moment the wiring is next but time is scarce..
I have used super glue to stick the magnets in place as suggested on the Mark 2 website
I and am about to do the installation - when I get time
Edited by Guest
Recommended Posts
bob-hepple 59
Stu
thanks for asking I'm putting the printed parts to gether today but just found that the magnets are not a tight fit they push into the recess but don't stop there. I'm pondering the use of super glue ?? any thoughts, the printer is not apart at moment the wiring is next but time is scarce..
Link to post
Share on other sites