Filament guide UM3

[Ziogianni84 3]

Never mind about the filament which doesn't pass thru the hole, but is the filament guide installed properly?

It looks a bit loose to me...

Edited October 19, 2017 by Guest

[Dim3nsioneer 557]

Nope. The filament has to go through the shackle.

[Ziogianni84 3]

Nope. The filament has to go through the shackle.

Hi, I know that indeed it was specified in the post's introduction "Never mind...." What I meant to say was that I see the whole filament guide being loose, not the filament itself. There's a small tab in the middle of the shunk, between the two spools, which I cannot hook anywhere. So if I apply pressure on the far end of the filament guide it swings.

[Dim3nsioneer 557]

Oh sorry, I must have overread this. The material guide, as the part is officially called, has indeed quite a lot of play. One could improve that a bit by adjusting the mold injection tool. However, a bit too much play is better in this case as not enough play.

Don't worry about the material guide falling down. As long as there is a spool on position 1 it cannot fall down unless it is very exposed to people touching it accidentally. The latch is just for limiting the movement of the spool in position 1.

[Ziogianni84 3]

Oh sorry, I must have overread this. The material guide, as the part is officially called, has indeed quite a lot of play. One could improve that a bit by adjusting the mold injection tool. However, a bit too much play is better in this case as not enough play.

Don't worry about the material guide falling down. As long as there is a spool on position 1 it cannot fall down unless it is very exposed to people touching it accidentally. The latch is just for limiting the movement of the spool in position 1.

Thanks! Just because I'm quite curious... regarding the latch, should it be closed in any way? Or should it work as is like a sort of stopper tab preventing the material guide from moving around (like actually you already explained)?

Edited October 21, 2017 by Guest