Jump to content
Ultimaker Community of 3D Printing Experts
vwguy16

Bed Leveling Issue using the Push Rotate button

Recommended Posts

Recently ive started to have 2 problems with my Ultimaker 2+ and im wondering if they are linked

I was having issues with a print where at random points in the print it would either fail or produce a weak point in the print, it looked like it was skipping a layer or jumping up 2.

At this point I decided to clean up the machine and re level the bed. I started to run through the process as normal using the rotate button to move the bed into position. It went a bit too high at first so i turned the button the other way but instead of lowering the bed it went up again, it went down eventually but then it was just going up and down randomly as i span it in the down direction. It seems like the button was not sending the correct signal to the board to control the bed height. it made me wonder if this is also the cause of the failing prints ?

Has any one seen this before? Any ideas what I can try to do to fix it ?

Cheers

Andy

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • How to 3D print with reinforced engineering materials
      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 0 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!