Cura 3.0.3 retraction problem.

[Stevespiel 0]

While trouble shooting my ongoing retraction problem in Cura 3.0.3 I noticed all of the G1 lines, shown below that do not contain an E value. I also noted all of the G0 lines generated to traverse to the next location where extrusion is needed. What is the reason these lines are generated? All of the G10 & G11 lines are present in the program but the extruder does not retract the filament. I have tried .5 to 5.5 mm retract distance and 25 to 55 mm/s speed.

G1 X134.661 Y98.765 E4599.02746

G1 X134.657 Y98.802

G1 X134.655 Y98.814

G1 X134.624 Y99.014

G1 X134.62 Y99.033

G1 X134.605 Y99.093

G1 X134.551 Y99.304

G1 X134.526 Y99.403

G1 X134.493 Y99.496

G1 X134.476 Y99.544

G1 X134.45 Y99.617 E4599.02864

G1 X134.438 Y99.531

G0 F9600 X134.444 Y99.479

G0 X134.436 Y99.417

G0 X134.424 Y99.332

G10

G0 X134.523 Y99.319

G0 X134.383 Y98.349

G0 X133.503 Y98.27

G0 X127.183 Y94.874

G0 X94.381 Y88.453

G0 X93.785 Y87.658

G0 X93.426 Y87.476

G0 X91.228 Y87.322

G0 X90.719 Y87.625

G0 X87.585 Y90.505

G0 X79.533 Y91.925

G0 X79.076 Y91.925

G0 X78.449 Y91.562

G0 X69.973 Y85.991

;TIME_ELAPSED:3552.515232

;LAYER:37

G0 X69.973 Y85.991 Z7.7

THANX  Steve

Edited October 30, 2017 by Guest

[AlexMaker 0]

Hello,

I am also facing a major issue using my UM2 and Cura 3.0.4.

I spent the day trying to deal with oozing/stringing without success :(

I will try installing a previous version of Cura...

[CapableQuad 10]

I am also having a large amount of stringing problems on my Ultimaker 3 using Cura 3.03 and Cura 3.04 that was not occurring with the last version of 2.x. I think that this may be a retraction issue. I am going back to 2.x until the dust settles.