kmanstudios 1,120
Try unchecking "Union Overlapping Volumes."
Thanks for your replies, and sorry for the slow response. I apparently don't get notifications when there's a reply.
I'm happy to upload the model, and I'll give 'Union Overlapping Volumes' setting a shot when my current print wraps up and I can try again.
Here's a link to the uploaded model:
I took a look at the file. It is a well built model. Turning off "Union Overlapping Volumes" left the internal voids intact.
I took a look at the file. It is a well built model. Turning off "Union Overlapping Volumes" left the internal voids intact.
Thanks, I'll give it a try when my current print is complete. In looking at the layer view, that's not working for me, but maybe Cura will get it right when it counts.
I took a look at the file. It is a well built model. Turning off "Union Overlapping Volumes" left the internal voids intact.
Thanks, I'll give it a try when my current print is complete. In looking at the layer view, that's not working for me, but maybe Cura will get it right when it counts.
Not sure what could be giving you and issue. This is what you should see. Cura 3.0.4
Edited by Guest
I took a look at the file. It is a well built model. Turning off "Union Overlapping Volumes" left the internal voids intact.
Thanks, I'll give it a try when my current print is complete. In looking at the layer view, that's not working for me, but maybe Cura will get it right when it counts.
Not sure what could be giving you and issue. This is what you should see. Cura 3.0.4
Ok, I had the cap in the same print volume, and it appears that causes a problem, at least with layer view, so the Union Overlapping Volume setting seems to do the trick once I remove that piece.
Thanks for the assist.
On 11/14/2017 at 4:25 PM, kmanstudios said:I took a look at the file. It is a well built model. Turning off "Union Overlapping Volumes" left the internal voids intact.
This worked for me! I've been searching for hours trying to figure this out! Thanks so much for the tip! It has made my day! :)
Recommended Posts
Nicolinux 288
Could you save it as a project and post it here? I bet some of the pros will come up with the right settings
Link to post
Share on other sites