Is this maybe a marlin firmware question? The firmware in your printer?
Or maybe this is a cura question? It sounds like a marlin question.
- 1
Is this maybe a marlin firmware question? The firmware in your printer?
Or maybe this is a cura question? It sounds like a marlin question.
Yes, I'd like to ask you to change this parameter and change it to 360.39.
@tinkergnome - do you understand what wong is talking about? Is this some number in marlin? One of the many Z distances in Marlin?
@wong - what kind of printer is this?
@gr5 - i have no clue, what is meant here
@wong - where are these numbers from? And which parameter do you want to change?
Perhaps the "Z_MAX_POS"? But this doesn't depend on the extruder count... the z-offset is most likely not that huge...
and the translation "second platform" is even more confusing...
Recommended Posts
gr5 2,225
Sorry - this part of the forum is english only. There is no chinese area but there is an "other languages area. here is the translation of above by google:
Link to post
Share on other sites