Cura 3.1.0 - Finer profiles for .1/.06 mm layers?

[Tiger91 1]

I just upgraded Cura, and while the older version had options for layers of .1/.06mm, this only has options for .15 and .2 mm.  Is this is a bug?  Or will that be added later?

 

Thanks

[nallath 1,123]

The profiles that it can select are also dependant on what the second extruder can print. For example; If the left extruder has 0.06, 0.1, 0.15, 0.2 and the right extruder supports 0.15 and 0.2, you can only select the 0.15 and 0.2

I assume that is what causing issues for you.

[Tiger91 1]

21 minutes ago, nallath said:

The profiles that it can select are also dependant on what the second extruder can print. For example; If the left extruder has 0.06, 0.1, 0.15, 0.2 and the right extruder supports 0.15 and 0.2, you can only select the 0.15 and 0.2

I assume that is what causing issues for you.

I think that might be my issue - I have breakaway in the right extruder.  However, the restriction still shows up even if I don't try to print using that material.