Jump to content
Ultimaker Community of 3D Printing Experts

First time using Nylon


orangesale
 Share

Recommended Posts

Posted · First time using Nylon

Hi guys,

 

First, let me tell you that I'm still a novice. I'm about to print Nylon, but I was wondering why is there no pre set layer height programmed in cura ?

What is wrong with my cura, even when I change material manually to PLA I am still not able to choose a pre set layer height.

 

The nylon I'm about to use is from Ultimaker.

From one material to another, the only thing that changes is the printing temperature.

4.jpg

5.jpg

1.jpg

2.jpg

3.jpg

  • Link to post
    Share on other sites

    • 4 weeks later...
    Posted · First time using Nylon

    Nylon is quite difficult.  But I love Nylon and print it all the time.  Did you get your answers?  I'm not sure what the question is but if you switch from "custom" mode to "recommended" mode I think you will see the presets (profiles) that you are asking about.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...