Firstlayer Problem

[ManuelW 2]

Hey there,

i have the problem with cura, that the first layer is always printed with to less plastic.

In S3D i have set a with of 200% for the firstlayer, that works fine. In Cura i set this also and

the printed line is much smaller.

 

All settings are the same as in S3D, first layer height, nozzle, wallthikness...

 

I dont know whats wrong in the Cura settings. maybe someone here have a hint for me.

 

Tanks

[gr5 2,224]

Are you using 1.75mm filament?  If so you have to tell cura that.  I think cura defaults to 3mm filament.

[ManuelW 2]

Yes i'm using 1.75mm and i set this in filament and printer settings

[93levya 0]

I've been having this problem recently myself, started with new version of cura. Not sure if it's the same issue, new files I've been slicing are starting the z height higher then it should be, and not squishing the layers properly. Printing old files indicates it's a slicer issue (the old files print fine). I don't have a solution yet, but figured I would mention it as I look for a solution, if you have any suggestions.

[ManuelW 2]

Maybe it is a relative/absolute problem in height? i can't solve this problem till now.

It looks like the offset is ignored an the table moves to a set height.