You are being helpful! It would be nice to figure out the source of the difference so it can be fixed. Can you save your project and post it?
Hi
I have attached the .3mf file.
This was done in Cura 3.2.1, I don't use 3.3.1 as there is a problem with it. I found the print times were longer in this version. I believe the bug has been fixed.
Print time for this is shown as 6:11, without adaptive layers turned on, 7:22.
If you need anything else just let me know.
The object itself came in as invalidly defined when opened in another program.
Unrelated, I think, the settings for your print didn;t come across - did you save the object, or a project (project will end in ".curaproject.3mf").
I'm wondering if your variable settings just ended up with the layers so tall they didn't print well. You can post a pic like this:
You can see I have layers up to 0.3mm, perhaps yours is larger?
AbeFM
Sorry I think I just saved it as .3mf file.
Thanks for showing me the layer thickness, I didn't know it was there, yellow is 0.35mm, no wonder it didn't print very well.
Here is the correct file.
Insert-Holder-R1-28-May-2018.curaproject.3mf.curaproject.3mf
- 1
Recommended Posts
Lez0 1
Hi Brulti
I used adaptive layers as at times it cut the print time by quite a bit, on one part it went from 16 1/2 hours to 14 hrs 11mins.
Link to post
Share on other sites