UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Ultimaker 2 - need to run the feeder motor to run in reverse
Posted
· Ultimaker 2 - need to run the feeder motor to run in reverse
Yes you have lots of choices.
1) UM2+ firmware will work as that goes the other way. You will have to adjust steps/mm most likely.
2) You can install tinker marlin - which I love - and which lets you toggle all feeder directions and adjust steps/mm in the menu.
3) You can swap the two wires in either (but not both) twisted pair. You just use a pin and push down on the angled piece of metal that holds the pin in and slide the pin out, then rebend that tiny piece of metal so it will start working again, swap the 2 wires and re-insert.
You will probably need to change the steps/mm regardless. I don't know if the um2+ firmware supports that or not although there is an gcode to set steps/mm. Followed by M500 to save it so it still works after power cycle.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,230
Yes you have lots of choices.
1) UM2+ firmware will work as that goes the other way. You will have to adjust steps/mm most likely.
2) You can install tinker marlin - which I love - and which lets you toggle all feeder directions and adjust steps/mm in the menu.
3) You can swap the two wires in either (but not both) twisted pair. You just use a pin and push down on the angled piece of metal that holds the pin in and slide the pin out, then rebend that tiny piece of metal so it will start working again, swap the 2 wires and re-insert.
You will probably need to change the steps/mm regardless. I don't know if the um2+ firmware supports that or not although there is an gcode to set steps/mm. Followed by M500 to save it so it still works after power cycle.
So it might be easiest to do #2 above.
Link to post
Share on other sites
Spaziofranco 0
I need to invert the wires of the feeder. Do you know if there's a video tutorial? I'm afraid to break the connector. Thanks!
Link to post
Share on other sites