Jump to content
Ultimaker Community of 3D Printing Experts

Some questions about general subject.


Recommended Posts

Posted · Some questions about general subject.

First I still don't understand for what are using this black plastic thing?

fb83a3fe3e45.jpg

Why on bowden tube are applyed blue scotch, and from what side it should be used?

I cant submit ticket somehow, so i will ask here. How much will cost shipping to Ukraine Belts Pack? About cost this my email: marakew196@gmail.com

Thanks in advance!

 

  • Link to post
    Share on other sites
    Posted · Some questions about general subject.

    The black clip holds the bolt in place. If you need to clean the bolt, you can pull the black clip off, and then slide the whole gear-wheel-and-bolt assembly out of the other side of the extruder.

    The blue tape on the bowden simply marks the end that goes on the extruder gear end. It's chamfered inside to make it easier to slide the filament in.

     

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...