Ah - THANK YOU - this is a new bug and now I finally understand it after seeing this post. 13.03.X doesn't have this bug. The easiest fix for you might be to make your "skin" .8mm thick instead of .4mm thick. Or go back to cura 13.03. Here is a quick explanation in a photo of the bug:
Infill was set to 50% for both images above.
Daid (author of cura) does most of his tests using cubes (but not all!) and this bug is more noticable in a cylinder.
Recommended Posts
illuminarti 18
Try reducing the infill overlap percentage.
The new Cura slicer calculates infill overlap differently. Take a look at this thread:
http://umforum.ultimaker.com/index.php?/topic/2404-1306x-infill-leaves-object
Link to post
Share on other sites