UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Bent layer heights on the first 1cm are related to the bed temperature. Lower it from 60C to 55C and that should be enough to help quite a bit. Normally you want the bed (actual surface glass temperature which is cooler than the 'bed temp") to be above 52C because PLA gets soft (like clay/plasticine) around 52C and this helps keep the PLA from warping off the bed.
But in your case you want higher accuracy as a higher priority so you want to lower the bed temp. You might even want to go down to 40C and put a layer of blue tape on there (wash the tape with isopropyl alcohol before printing on it to remove the waxy layer).
You do not want a draft shield as this will compound the problem. PLA needs tons of cooling.
It would also of course help to drop the speed farther and print slower. For extra accuracy I drop down to 25mm/sec (for all printing speeds!!!) and drop the temp by 10C.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
Bent layer heights on the first 1cm are related to the bed temperature. Lower it from 60C to 55C and that should be enough to help quite a bit. Normally you want the bed (actual surface glass temperature which is cooler than the 'bed temp") to be above 52C because PLA gets soft (like clay/plasticine) around 52C and this helps keep the PLA from warping off the bed.
But in your case you want higher accuracy as a higher priority so you want to lower the bed temp. You might even want to go down to 40C and put a layer of blue tape on there (wash the tape with isopropyl alcohol before printing on it to remove the waxy layer).
You do not want a draft shield as this will compound the problem. PLA needs tons of cooling.
It would also of course help to drop the speed farther and print slower. For extra accuracy I drop down to 25mm/sec (for all printing speeds!!!) and drop the temp by 10C.
Link to post
Share on other sites