Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
If you hover your mouse over the time it will show you how much time is spend on different step like infill, travel, retract... so it will give you an idea where to save time. You might wanna look at you speed to see if it's low, maybe your infill is set too high like if you have 100% infill it will use the top/bottom printing speed and it's often slower than infill speed.
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
Jeremi 4
If you hover your mouse over the time it will show you how much time is spend on different step like infill, travel, retract... so it will give you an idea where to save time. You might wanna look at you speed to see if it's low, maybe your infill is set too high like if you have 100% infill it will use the top/bottom printing speed and it's often slower than infill speed.
Link to post
Share on other sites
Craftylines 0
Hi, Thank you for yr response. I managed to get back to correct times by going back to the older version of Cura.
Link to post
Share on other sites