Cura won't accept build volume

[twiereng 1]

My Ultimaker 2+ has a build volume of 223 x 223 x 205 mm. My print is 203.2 x 203.2 x 196.85 mm. My Cura 3.4.1 will not accept this build volume. If I scale it down to 92 % it works. What am I doing wrong? Screen shot attached.

 

Thanks, Theron

[obewan 37]

Only way i can reproduce it is when i have 'brim' selected,  turn off brim or reduce its size and it should fit ok.

 

Edited September 16, 2018 by obewan

[twiereng 1]

Of course, why didn't I think of that. Brim exceeds the size. Let's face it I'm just getting old. ?

 

Thanks, Theron