cure 3.5 infill?

[jeb1 1]

I told it 75% infill, it looked like 10%

is there some new infill option to fix this?

it worked under 3.4.1

[Nicolinux 288]

Hi,

 

did you change other settings related to infill or did you add an infill/no-infill mesh? It would be helpful to share a screenshot of the "layer view" and/or the Cura project file.

[jeb1 1]

all I did was install the new version, all settings were the same

[jeb1 1]

I did reinstall 3.4.1 and it did the same thing, so I'm lost

the model is solid

 

I'll check other things

big bearing block.stl

Edited October 3, 2018 by jeb1
infill does not seem to work on this model and I don't know why

[jeb1 1]

curious, running the print with a 1mm nozzle resulted in very little infill, running with 0.5mm nozzle had lots

so not sure why

[Smithy 1,145]

I think that is normal, because with the 1mm nozzle the line thickness is 200% of the 0.5 mm nozzle. Therefore also less infill, because the wall is thicker. Infill is, as far as I know, calculated how much material is used for infill, so if the line is thicker, you see visible less infill patterns.