Cura 3.5 too much support

[qwarks 1]

Hi all.

 

After updating to Cura 3.5 i cannot control the support as in earlier versions..

I have a 90 degree ledge that is touching the buildplate and this is the only part that i need to support. All other overhangs are well within the set parameters and should not need support.

 

Why is it adding so much support?

 

 

[qwarks 1]

no one?

[burtoogle 516]

46 minutes ago, qwarks said:

no one?

Sorry, I can't help, not my area of expertise. You need the support department!

[Carla_Birch 116]

A image of the model without the supports would be handy, no one can see whats going on behind the supports.