I have the same problem on an HP 2-in-1 laptop. 3.5.1 works great on an Asus, Dell, and a couple others. Same program and settings, but closes when saving GCODE.
UPDATE - Found the resolution moments after posting. Preferences>General>Privacy - make sure "Send (anonymous) print information" is unchecked. This was the only change made, and now prints. Not sure if it has something to do with Cura of settings within Network protocol, ect.
Huh. Weird. We had some issues with this a few months ago, but we fixed that at some point. Ugh, back to the drawing board then...
-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
nallath 1,124
I don't see anything in the logs that would explain why it's crashing. Can you save to UFP or any other filetype?
Link to post
Share on other sites