Another Camera issue UM3/cura

[RubberRudder 0]

UM3, camera blank after replacing wifi card. Can connect and send prints, but no video. Monitor flashes about every 2 seconds from "grey available" to "blue with the progress bar.

Thanks for looking!
Firmware is latest, Cura 3.6 beta.

[RubberRudder 0]

Bump

 

[Brulti 177]

I the printer is recent, contact customer service from your resseller.

[RubberRudder 0]

Solved,

Cura connect config files were corrupted, factory reset and run the connect setup.
  Use this address to test your camera connection http://192.168.0.105:8080/?action=stream

[myRobot 0]

I have this issue and haven't been able to fix it. I did factory reset multiple times.

[RubberRudder 0]

 Paste this address in your browser to verify http://192.168.0.105:8080/?action=stream.
Run Cura connect.

If the wifi is working and the camera runs in a browser it's a cura configuration conflict, if not then guess like I do and replace camera hardware. 🙂