Updated Ultimaker Drawings

[rigelsix 0]

Is it possible to update the open source laser drawings to the Revision 4 design?

I have a revision 3 and I would like to cut out some of the changed parts and replace them, an possibly build a second machine.

 

[Daid 306]

The rev4 machine is actually cut from the 3.5.7 files from https://www.youmagine.com/designs/ultimaker-laser-cut-drawings

 

[rigelsix 0]

Awesome, thanks for the link. All the info on the ultimaker site and reprap.org still point to the drawings on thingiverse.

 

[drayson 75]

@daid, was looking for the drawings but gut just this note:

"You are not authorized to access this page."

Could you please make those drawings available again?

[meduza 191]

@drayson: https://www.youmagine.com/designs/ultimaker-laser-cut-drawings--2

Or if you go to the Ultimaker GitHub you can actually get Rev3.5.9 of the drawings:

https://github.com/Ultimaker/UltimakerOriginal/blob/master/UltimakerLasercutDrawingsV1_6mmRev3.5.9.ai

Edited October 1, 2016 by Guest