UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
[Cura 3.6] Floating supports at layer heights less than .1
Posted
· [Cura 3.6] Floating supports at layer heights less than .1
Rotated the same design so the sword was in a vertical, and now I get small bits of support in the middle of the at the end of the sword as well as floating around the outside towards the hilt (as well as other places). Project attached.
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
sigwx 0
Rotated the same design so the sword was in a vertical, and now I get small bits of support in the middle of the at the end of the sword as well as floating around the outside towards the hilt (as well as other places). Project attached.
AI3M_Thenatarius_supports_in_object.3mf
Link to post
Share on other sites