UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
ultiarjan 1,223
Volgens mij zijn ze inderdaad 1 cm.
De grijze buitenrand is dynamisch en past zich aan afhankelijk van instellingen.
Als je bijvoorbeeld dual-extrusion print zal de rand rechts zich aanpassen omdat je effectieve ruimte kleiner wordt.
Ook b.v. het aanpassen van je "brim" heeft effect. Print je met een bredere brim, dan hou je minder effectieve ruimte over voor je print.
Link to post
Share on other sites