UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
You can set "horizontal expansion" to 0.3mm to get all the walls up to 0.8. But it will make everything 0.3mm thicker. Anyway this is the simplest solution I can think of. I recommend at least 0.8mm walls. If you want to go thinner - say 0.6mm walls then you will need to enable "print thin walls".
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
You can set "horizontal expansion" to 0.3mm to get all the walls up to 0.8. But it will make everything 0.3mm thicker. Anyway this is the simplest solution I can think of. I recommend at least 0.8mm walls. If you want to go thinner - say 0.6mm walls then you will need to enable "print thin walls".
Link to post
Share on other sites
Luke67 0
Ok thank you, I will try that
Link to post
Share on other sites