Cura 4 and material diameter

[Peirof 0]

Hi,

 

In Cura 3, where you add a printer, can select the diameter of Nozzle, and this changes globally all diameters materials.... but in cura 4, this menu, its not in the same localitation....

 

Where/How i can change the nozzle diameter of my printer?

 

Thanks

[peggyb 171]

you can set the 'Line Width' in the Quality tab to the size you want.

[Peirof 0]

But... i think its not the same...

 

These setup seems for Nozzle diameter you have instaled, not for filament diameter... 

[Smithy 1,144]

Thats right, you have to install the plugin "printer settings" from the marketplace which installs in the settings box on the right where you can find the diameter setting again.

[Smithy 1,144]

Another possibility is to change it in the materials pane in preferences.

But I guess you have to add your own profiles to change them, because you cannot edit the stock profiles.

[peggyb 171]

the marketplace is almost empty in 4.0 beta, no printer settings. So I guess you still have to use 3.6 to do the settings. Not sure if 4.0 will take them from there?

[Smithy 1,144]

Yes, as I learned from another thread, the plugin structure has changed between 3.6 and 4.0 so, the plugins need an update. I guess thats the reason why the marketplace is nearly empty at the moment.

 

But the materials pane in preferences should work.

[Peirof 0]

Hi,

 

until now, i am using a printer, not my model... but now i have erase it, and add a custom printer.... and in this printer can select the filament diameter....

 

this solves my issue

[alienrelics 0]

Installed the plugin Printer Settings from the Marketplace. Cura 4.3.0. Rebooted Cura. Nothing extra has appeared. Did I do something wrong?

 

All I need to do is alter the diameter. My measured filament diameter is 1.722mm, and my prints show slight under extrusion.

[alienrelics 0]

So I followed the second bit of advice, I duplicated the generic PLA and altered its diameter.