New Printer Profile help

[Rsteel517 0]

I just got a MatterHackers Pulse 3d printer and need help setting up a Cura profile for it.  Does anyone have a baseline profile I could use?

 

If this isnt the right place for this, just let me know.

 

I like Cura's interface and support settings a little better then i do MatterControl's.

[gwatson1990 1]

Don't know much about the printer but it looks to be a Prusa clone of sorts. You could probably start by picking the Prusa I3 profile and adjust the bed size as needed in the profile. I would also make sure that your retraction is set to less than 3mm as the Pulse looks to have an E3D hot-end and you wouldn't want to risk a jam with PLA (not sure if it's all metal though). Hope this helps! If you haven't done this already lol