Ok, the Wiki references a completed threaded rod. Mine has a flange (about an inch) narrow of now thread...which makes sense to thread into the coupling
However the top...the wiki shows that it is capped off like the two shafts for the z to glide up and down. My kit, there is no such thing So the top of the z screw looks like it sits a mm or two beneth the wood top piece
This sound right?
Recommended Posts
LePaul 331
I got it installed....made sure the left side was on really snug....but nothing mechanically holds that in...is there anything I can/should do to make sure this does wiggle out in the future? Or will the rods be plenty of force to keep things in line?
Link to post
Share on other sites