I believe this is on the start/end gcode tab in cura settings.
I believe this is on the start/end gcode tab in cura settings.
Aha! I have never used that tab in the previous versions. I can see it now, thank's guys!
(Back after 2 weeks vacation)
Note, the newer CuraEngine assumes that the firmware will limit the Z speed. I highly recommend configuring your firmware so that the Z speed is limited to what your machine can handle. As it will also do Z moves at high speed.
Recommended Posts
illuminarti 18
You can simply change the start gcode in Cura to make it do it at whatever speed you want to.
You may also be able to set a speed limit in your firmware, so that any move speeds are capped, and the printer doesn't try to move faster than it can.
Link to post
Share on other sites