Jump to content

Help Tuning CPE Dary Grey on S5

Deeps

By Deeps
in Materials & profiles

 Share

Recommended Posts

Deeps

Deeps 0

Posted
Posted · Help Tuning CPE Dary Grey on S5

I've been working with Ultimaker CPE Dark Grey for a few days now and it seems like I'm getting more stringing and 'goobers' than I expected. I'm using the default profile that was set by the NFC chip in the spool. 

I went through a roll of PLA first on the S5 and the print quality was close to perfect.

Since loading up the CPE I keep getting print quality like you see in the image below. I tried dropping the temp by 5 deg or so to see if the stringing was less but can't really perceive a difference. 

Any suggestions are much appreciated. 

IMG_7228.thumb.JPG.3be4743e4bdcff02e747bff9ada70402.JPG

    • Link to post
    Share on other sites
    Smithy

    Smithy 1,144

    Posted
    Posted · Help Tuning CPE Dary Grey on S5

    Printing CPE is not so easy, I always fight with the surface quality, so I use CPE only when I have to do it.

    But check the setting Combing and turn it off if it is enabled, this helps a lot against stringing.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...