UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I would turn off retract before outer wall. It probably oozed a bit during travel moves and then underextruded on the pillars.
For something like this, you are a lot better off not printing it as one piece. Not only would you have a heap of print time and PVA but you could get a lot better quality pillars. If you designed this yourself then you can make the pillars slot into place and add a dab of glue.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Labern 774
I would turn off retract before outer wall. It probably oozed a bit during travel moves and then underextruded on the pillars.
For something like this, you are a lot better off not printing it as one piece. Not only would you have a heap of print time and PVA but you could get a lot better quality pillars. If you designed this yourself then you can make the pillars slot into place and add a dab of glue.
Link to post
Share on other sites
APuser 0
Thank you, pretty sure this was a temperature issue, and appreciate advice on recommended profile settings.
Link to post
Share on other sites