Jump to content

Feature request: Print or Iron top skin in only one direction (in zig zag or line mode)

selland74

By selland74
in UltiMaker Cura

 Share

Recommended Posts

selland74

selland74 0

Posted
Posted · Feature request: Print or Iron top skin in only one direction (in zig zag or line mode)

When printing or ironing a top skin in zig zag or line mode, it will cover most of the area going one direction (say left to right) then come back and fill in some spots going right to left.  this leaves a different appearance to those areas (see picture, bright and dark areas).  I haven't found any way to control this.  Could this be added?  thanks

IMG_20190401_223201.jpg

    • Link to post
    Share on other sites
    pbackx

    pbackx 11

    Posted
    Posted · Feature request: Print or Iron top skin in only one direction (in zig zag or line mode)

    Sorry I can't help you. I doubt this can be configured. There's a similar issue with the bottom layer that can be really visible with some of the more reflective filaments 

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...