Jump to content

Recommended Posts

Posted · Problems with PVA after firmware update 5.2.11

Hi i'm not sure if its the firmware, but its the only thing that have changest between the two prints.

 

After updating to firmware 5.2.11 (S5) i have a problem with my Pva leaving a lot of surface scaring on the Pla.

The two pictures are from the same Cura project, same settings, same Pla and Pva spole. same print cores. Printede with three days apart, Pva is in a drybox, so should not make a difference.

only thing that have changest is the firmware update in between the two prints.

 

any ideers? 

 

Print 1

20190612_091824.thumb.jpg.ad99b26cd26c104ffb572498af4a3e97.jpg

 

Print 2

20190612_091751.thumb.jpg.1bf832fb1afbee9641662d2b69d574af.jpg

 

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 4 replies
    ×
    ×
    • Create New...