Problems with PVA after firmware update 5.2.11

[NBull 14]

Hi i'm not sure if its the firmware, but its the only thing that have changest between the two prints.

 

After updating to firmware 5.2.11 (S5) i have a problem with my Pva leaving a lot of surface scaring on the Pla.

The two pictures are from the same Cura project, same settings, same Pla and Pva spole. same print cores. Printede with three days apart, Pva is in a drybox, so should not make a difference.

only thing that have changest is the firmware update in between the two prints.

 

any ideers? 

 

Print 1

 

Print 2

 

 

[Dim3nsioneer 558]

The Cura version is the same (which?)? Or could one be Cura 4.0 and the other Cura 4.1?

[NBull 14]

Same Cura both are 4.0 and same computer 😕