UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The first line tells the bed to go to 0.1mm. The second line tells the printer to from now on (until the z axis is homed) consider that position as 0mm. So effectively every following Z coordinate will be 0.1 mm further away from the bed then after homing the z axis.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ahoeben 1,992
This is correct.
The first line tells the bed to go to 0.1mm. The second line tells the printer to from now on (until the z axis is homed) consider that position as 0mm. So effectively every following Z coordinate will be 0.1 mm further away from the bed then after homing the z axis.
Link to post
Share on other sites
TMicke 23
Thank you! That explains it perfectly to me.
/Micke
Link to post
Share on other sites