[FR] Make "Infill Layer Thickness" behave like "Support Z Distance"

[kulfuerst 6]

Hello everyone,

 

it would be wonderful if "Infill Layer Thickness" could also round up to the next multiple of the layer thickness, the same way the "Support Z Distance" does. That way it wouldn't need to be changed with every print and one could set it once and never worry about it again. The same way that many people have set the "Support Z Distance" to a value like "0.165" to always have the Z distance be a multiple of the layer thickness until 0.17mm layer height, at which the "Support Z Distance" automatically starts being equal to the layer height.

 

Currently, the "Infill Layer Thickness" is forbidden to be smaller than the Layer height and only rounds down.

 

Thank you everyone for your consideration 🙂