Cura won’t run with 3 monitors

[wimorrison 0]

I have downloaded Cura 4.2 and now find that it won’t run when I have 3 monitors connected which I generally do  as the computer is used for more than just Cura.

 

it is definitely a Cura issue as when I disconnect a monitor Cura runs again, but with all 3 connected it displays the startup screen, goes to the main Cura screen but it is all white and then closes without showing the actual program.

 

what could be wrong - every other program runs correctly?

 

Windows 10 Pro 1903, 16gb 

[ahoeben 1,965]

Could you try the following:

 

In %APPDATA%\cura\4.2\Cura.cfg, in the [general] section, remove the lines starting with window_left and window_top. Then start Cura.

 

This should start Cura on the primary display.

[wimorrison 0]

Yeh - that cured it, thank you 🙂

[ahoeben 1,965]

Ok, now you should be able to move the Cura window to other monitors, but remember to move it back to the primary monitor before you close it. Or else you have to edit the config file again.

[burtoogle 514]

Hi @ahoeben, I've seen this fix mentioned a couple of times recently, would it make sense for Cura on closing to either detect when those lines should be deleted because there's more than one monitor or just delete them anyway?

 

[ahoeben 1,965]

Those two lines work fine on my multi monitor setup. I wouldn't know of a way to detect setups where it does not work. There could be a preference to not store the window position on exit.

[burtoogle 514]

Does this problem only occur on Windows systems?

[ahoeben 1,965]

As far as I know, yes.

[ahoeben 1,965]

Here is a PR that adds a preference to not restore the position and size of the window, thus keeping Cura on the primary display:

https://github.com/Ultimaker/Cura/pull/6385

Affected users would still need to be able to start Cura to reach the preferences dialog (or edit cura.cfg to add the preference once)