Second Extruder Leaves Filament on the Print

[AfroPsycho 1]

Hi,

 

When I printing with dual extruder
The second extruder leaves filament on the other part of the print
I am using the exact same settings for the filament that I know works best
And also the print quality is low as you can see on the second picture
I am using the ooze shield and the prime tower at the same time

[Smithy 1,144]

You have not said which printer you are using, but does your printer raise the unused nozzle or does it remain at the same height as the active one?

[AfroPsycho 1]

2 minutes ago, Smithy said:

You have not said which printer you are using, but does your printer raise the unused nozzle or does it remain at the same height as the active one?

I am using a non popular printer 4GenPro by 3D4E 

the extruders stays in the same height 

[Smithy 1,144]

Just now, AfroPsycho said:

the extruders stays in the same height

 

This is your main problem, the unused nozzle will travel over your object and leave its marks.
You can only try to play with the Retract settings and eventually go down with the standby temperature to prevent the nozzle from dripping.